This paper deals with fundamental investigation for machining error in elastomer endmilling. In the conventional metal machining, cutting force during endmilling is one of the most important factors to machining error. Because of low-rigidity of elastomers, influence of cutting force may be more important. Therefore, relationship between the cutting force and machining error is investigated. From the experimental results, it becomes clear that cutting forces affect to the machining error only in the down cut machining.
雑誌名
室蘭工業大学紀要
巻
62
ページ
55 - 58
発行年
2013-03-18
注記
特集 : Special Section for the Papers Presented at the Symposium on Mechanical Engineering, Industrial Engineering, and Robotics held at Noboribetsu, Hokkaido, Japan on 11 - 12 January 2012
Experimental investigation of machining error in elastomer endmilling
kiyo62_pp55-58.pdf
(632.76KB)
